Data Sheet

Product dimensions

Figure 1. Device dimensions and mounting hole details

USB cable length: 300mm +/- 20 mm

Software and operation

The USB Accelerator doesn't require any software installed, but the host computer to which it's attached must install

the Edge TPU runtime and API library. For instructions, see the Get Started guide.

For information about how to create models and run inferences the Edge TPU, read TensorFlow models on the Edge

TPU.

Performance settings

When you first set up the USB Accelerator, you can select whether to use the default or maximum clock frequency.

The maximum clock frequency runs at 2x the default setting, which increases the inferencing speed, but also increase

power consumption.

Caution: If you enable the maximum operating frequency, the USB Accelerator becomes very hot to the

touch during operation and might cause burn injuries. Either keep the device out of reach when using with

the maximum frequency or instead use the default clock frequency to avoid injury.