SDS
05/01/2019Revision:
Page: 4 of 10
Goof Off Hardwood Latex Paint Remover
SAFETY DATA SHEET
08/27/2018Supersedes Revision:
5. FIRE FIGHTING MEASURES
Flash Pt:
0.00 F Method Used: Setaflash Closed Cup (Rapid Setaflash)
Self-contained respiratory protection should be provided for fire fighters fighting fires in
buildings or confined areas. Storage containers exposed to fire should be kept cool with
water spray to prevent pressure build-up. Stay away from heads of containers that have
been exposed to intense heat or flame.
Fire Fighting Instructions:
Vapors are heavier than air and may travel along the ground or be moved by ventilation
and ignited by heat, sparks, flame, and other ignition sources distant from material
handling point. Never use welding or cutting torch on or near container (even empty)
because product (even residue) can ignite.
Material can be a static accumulator.
Flammable Properties and
Hazards:
Autoignition Pt:
No data.
Explosive Limits:
LEL: No data. UEL: No data.
NFPA Class IB
Use carbon dioxide, dry powder, or foam.
Suitable Extinguishing Media:
Do not use a solid water stream, as this may spread the fire.
Unsuitable Extinguishing
Media:
Carbon monoxide and carbon dioxide.
Hazardous Combustion
Products:
6. ACCIDENTAL RELEASE MEASURES
Vapors may cause flash fire or ignite explosively.
Clean up: Keep unnecessary people away; isolate hazard area and deny entry. Stay
upwind, out of low areas, and ventilate closed spaces before entering. Shut off ignition
sources; keep flares, smoking or flames out of hazard area. Use non-sparking tools.
Use proper bonding and grounding methods for all equipment and processes. Keep out
of waterways and bodies of water. Be cautious of vapors collecting in small enclosed
spaces, sewers, low lying areas, confined spaces, etc.
Small spills: Take up with sand, earth or other noncombustible absorbent material and
place in a plastic container where applicable.
Large spills: Dike far ahead of spill for later disposal.
Waste Disposal: Dispose in accordance with applicable local, state and federal
regulations.
Steps To Be Taken In Case
Material Is Released Or
Spilled:
7. HANDLING AND STORAGE
Do not use in small enclosed spaces, such as basements and bathrooms. Vapors can
accumulate and explode if ignited.
Read carefully all cautions and directions on product label before use. Since empty
container retains residue, follow all label warnings even after container is empty.
Dispose of empty container according to all regulations. Do not reuse this container.
Do not use this product near any source of heat or open flame, furnace areas, pilot
lights, stoves, etc.
Precautions To Be Taken in
Handling:
Licensed to W.M. Barr and Company
GHS format