Quick Installation Guide

4
Quick Installation Guide V1.0-2022-03-20
No. Name Description
1 DHCP
• Enable DHCP when the router is in dynamic IP mode.
• Disable DHCP when a switch is used or when the router
is in static IP mode.
2 IP Address
• Do not congure the parameters when DHCP is enabled.
• Congure the parameters according to the router or
switch information when DHCP is disabled.
3 Subnet Mask
4 Gateway Address
5 DNS Server
Troubleshooting04
No. Problem Solutions
1
Cannot nd CCM-
BLE**
1. Make sure that the inverter is powered on and the Ezlink
device is connected properly.
2. Make sure that the smart device is within the
communication range of the Ezlink device.
3. Restart the inverter or short press to restart the Ezlink.
2
Unable to connect to
CCM-BLE**
1. Make sure that no other smart device is connected to
Solar-WiFi**.
2. Restart the inverter or short press to restart the Ezlink,
then reconnect CCM-BLE**.
3
Indicator double
blink
1. Make sure that the router is powered on.
2. Make sure that the the LAN cable is connected tightly.
4
Indicator
quadruple blink
1. Make sure that the cables are connected properly, and
the router can access the internet.
2. If the problem persists, contact the after sales service.
5 Indicator o • Check whether the inverter is powered on.