Installation Instructions

16
HIGH VOLTAGE! DISCONNECT ALL POWER BEFORE SERVICING.
MULTIPLE POWER SOURCES MAY BE PRESENT. FAILURE TO DO SO
MAY CAUSE PROPERTY DAMAGE, PERSONAL INJURY OR DEATH.
WARNING
J1
PN. B1368274
PJ6
PJ2
PJ4
OT1
OT2
HUM
12345678
W1 W2
COM
W2
DI
P
24 VAC
W2
W1
OUTDOOR
HEATPUMP
J2 J3
1
4
1
5
Y/Y2OT2 HUM
HUMIDISTAT
OT1OTC
W/W2E\W1
THERMOSTATS
GOODMAN MFG. CO. L.P.
COM W2
HEATPUMP
W2
W2
IF NEEDED
HUMIDISTAT
(OPTIONAL)
REMOVE
PRODUCTION
WIRE Y1-O
SEE NOTE 4
2nd STAGE HEATER
OUTDOOR
THERMOSTAT
NOTES:
1.) Y ENABLES HI SPD FAN COOLING
2.) E ENABLES LO SPD FAN HEATING
W2 ENABLES LOW SPD FAN HEATING
W2 AND OT2 CLOSED ENABLES HI SPD FAN HEATING
3.) OT1 PJ2 MUST BE CUT FOR THIS CONFIGURATION
4.) CUT HUM PJ6 JUMPER IF USING HUMIDISTAT
STAT OPENS ON HUMIDITY RISE
5.) DIP SWITCH #4 MUST BE IN THE "ON" POSITION
HEATPUMP - 2 STG EMHT 2 STAG AUX - 1 OUTDOOR T-STAT
1ST STAGE HEATER
O
ROOM
THERMOSTAT
HEATPUMP
Figure 25
J1
PN. B13682704
HUM
RYCONCOM
ED
TC
H
N
CR
CONDENSER
DS1
J2 J3
1
4
1
5
RC HUM
RYCON
COM
ED
CON DEN SE R
IF
O
HUMIDISTAT
(OPTIONAL)
SEE NOTE 4
ROOM
THERMOSTATHEATPUMP
NOTES:
1.) Y ENABLES HI SPD FAN COOLING
2.)
W2 AND OT1 CLOSED ENABLES LOW SPD FAN HEATING
W2 AND OT2 CLOSED ENABLES HI SPD FAN HEATING.
E ENABLES LOW SPD FAN HEATING
3.) IF OT2 PJ4 AND OT2 PJ2 MUST BE CUT FOR THIS
CONFIGURATION
4.) CUT HUM PJ6 JUMPER IF USING HUMIDISTAT
STAT OPENS ON HUMIDITY RISE
5.) DIP SWITCH #4 MUST BE IN THE “ON” POSITION
NO AUX HEAT IN HEATPUMP MODE UNTIL OUTDOOR T’STAT CLOSES
REMOVE
PRODUCTION
WIRE Y1-O
Figure 26
Wiring is subject to change, always refer to the wiring diagram on the unit for the most up-to-date wiring.