Installation Manual

5151 San Felipe, Suite 500, Houston, TX 77056

Quality Makes the Difference!

All of our systems are designed and manufactured with the same high quality standards regard-

less of size or efficiency. We have designed these units to significantly reduce the most frequent

causes of product failure. They are simple to service and forgiving to operate. We use quality

materials and components. Finally, every unit is run tested before it leaves the factory. That’s

why we know. . . There’s No Better Quality.”

NOTE: SPECIFICATIONS AND PERFORMANCE DATA LISTED HEREIN ARE SUBJECT TO CHANGE WITHOUT NOTICE

• Products

• Warranties

• Customer Services

• Parts

• Contractor Programs and Training

• Financing Options

Visit our website at www.daikincomfort.com, www.goodmanmfg.com or www.amana-hac.com for information on:

FIGURE 15

NOTE: On earlier (M) models it may be necessary to

notch or cut heater kit shroud to accomodate

screws in heater (Figure 14).

NOTE: To accomodate 6-gauge wires, it may be necessary

to make cuts as shown on the heater kit cover. Ensure

grommet edging is used along sharp edges to prevent

injury (Figure 15).

NOTE: If necessary to connect line power to unit, drill a 1”

hole at the coordinates provided in Figure 16.

FIGURE 14

FIGURE 16