Service Manual

ManualsBrandsGoodman Manuals16 seer self contained heat pumps5 Ton, 15.5 SEER, GPH1660H41, R410A Two-Stage Packaged Heat Pump

PRODUCT DESIGN

Air for condensing (cooling) is drawn through the out door coil by

a propeller fan, and is discharged vertically out the top of the

unit. The out door coil is designed for .0 st atic. No additional

rest riction (ductwork) shall be applied.

Conditioned air is drawn through the filter(s), field installed,

across the evaporat or coil and back into the conditioned space

by the indoor blower.

COM PRESSORS

Some H series package units use the Compliant Scroll compres-

sor, instead of traditional reciprocating compressors. St ill other

models use reciprocating compressors.

A scroll is an involut e spiral which, when matched with a mat ing

scroll form as show n, generates a series of crescent shaped gas

pockets bet ween t he t wo members.

During compression, one scroll remains st ationary (fixed scroll)

while the other form (orbiting scroll) is allowed t o orbit (but not

rot at e) around the first form.

As this motion occurs, the pockets between the t wo forms are

slowly pushed t o the cent er of the two scrolls while simult a-

neously being reduced in volume. When the pocket reaches the

center of the scroll form, t he gas, which is now at a high pres-

sure, is discharged out of a port locat ed at the cent er.

During compression, several pockets are being compressed si-

multaneously, result ing in a very smoot h process. Both the suc-

tion process (out er port ion of the scroll members) and the dis-

charge process (inner portion) are continuous.

Some design characteristics of the Compliant Scroll compressor

are:

• Compliant Scroll compressors are more tolerant of liquid re-

frigerant .

NOTE: Even t hough the compressor section of a Scroll com-

pressor is more tolerant of liquid refrigerant , continued

floodback or flooded st art condit ions may wash oil from the

bearing surfaces causing premat ure bearing failure.

• These scroll compressors use POE or polyolester oil which is

NOT compat iable wit h mineral oil based lubricants like 3GS.

POE oil must be used if additional oil is required.

• Compliant scroll compressors perform "quiet" shut downs that

allow the compressor to rest art immediat ely without the need

for a time delay. This compressor will rest art even if the sys-

tem has not equalized.

NOTE: Operating pressures and amp draws may differ from

standard reciprocat ing compressors. This informat ion can be

found in the unit's Specification Sheets.

INDOOR BLOW ER M OTOR

All * PC15/ * PH16 model package units use a EEM blower motor.

The EEM motor is a 3 Phase brushless DC (single phase AC in-

put), ball bearing construction mot or with an int egral control

module wit h an internal FCC B EM I filter.

The EEM motor is cont inuously powered with line voltage. The

swit ched 24 volt cont rol signal is controlled by the t hermostat

in the cooling and heat pump mode.

ELECTRICAL W IRING

The units are designed for operation at the volt ages and hert z as

shown on the rating plate. All internal wiring is complet e. En-

sure t he pow er supply to the compressor contactor is brought

to t he unit as show n on the supplied unit wiring diagram. The

24V wiring must be connected bet w een the unit control panel

and the room thermost at.

WARNING

TO AVOID PERSONAL INJURY OR DEATH DUE TO

ELECTRIC SHOCK, WIRING TO THE UNIT MUST BE

PROPERLY POLARIZED AND GROUNDED.

WARNING

TO AVOID THE RISK OF PROPERTY DAMAGE,

PERSONAL INJURY OR FIRE, USE ONLY COPPER

CONDUCTORS.