GM9S80 Installation Manual
4
3.
4.
within a nine month statute of limitations.
•
indemnity bond.
• Original paid freight bill or indemnity in lieu thereof.
•
and other discounts or reductions.
•
representative at the time damage is reported to carrier.
The carrier is responsible for making prompt inspection of
damage and for a thorough investigation of each claim. The
distributor or manufacturer will not accept claims from deal-
ers for transportation damage.
-
cal components.
servicing to protect the integrated control module from dam-
age. By putting the furnace, the control, and the person at
the same electrostatic potential, these steps will help avoid
exposing the integrated control module to electrostatic dis-
charge. This procedure is applicable to both installed and
non-installed (ungrounded) furnaces.
1.
integrated control module or any wire connected to the
control prior to discharging your body’s electrostatic
charge to ground.
2.
furnaces near the control. Any tools held in a person’s
hand during grounding will be discharged.
3. Service integrated control module or connecting wiring
not to recharge your body with static electricity; (i.e., do
objects, etc.). If you come in contact with an ungrounded
object, repeat step 2 before touching control or wires.
4.
installing the control on a furnace. Return any old or
new controls to their containers before touching any
ungrounded object.
Before installing this unit, please read this manual thoroughly
-
hered to, including but not limited to: unit maximum external
-
trical connections, circulating air temperature rise, minimum
-
This furnace is primarily designed for residential home-heat-
ing applications. It is NOT
mobile homes, trailers or recreational vehicles. Neither is it
be installed indoors (i.e., attic space, crawl space, or
garage area provided the garage area is enclosed with an
operating door).
This furnace can be used in the following non-industrial
commercial applications:
In such applications, the furnace must be installed with the
following stipulations:
• It must be installed per the installation instructions
provided and per local and national codes.
• It must be installed indoors in a building constructed
on site.
• It must be part of a ducted system and not used in a free
air delivery application.
• It must not be used as a “make-up” air unit.
• All other warranty exclusions and restrictions apply.
This furnace may be used as a construction site heater
if all of the following conditions are met:
• The vent system is permanently installed per these
installation instructions.
•
used and can cause long term equipment damage.
vibration must not be used during construction.
• Return air ducts are provided and sealed to the furnace.
•
•
during construction and upon completion of construction.
• The input rate and temperature rise are set per the
furnace rating plate.
• 100% outside air must be used for combustion during
construction. Temporary ducting may be used to supply
outside air to the furnace for combustion – do not connect
this duct directly to the furnace. Size this duct according