GM9S80 Installation Manual
2
Adhere to the following warnings and cautions when install-
ing,adjusting, altering, servicing, or operating the furnace.
To ensure proper installation and operation, thoroughly read
application of this product.
FIRE OR EXPLOSION HAZARD
Failure to follow the safety warnings exactly could result
in serious injury, death or property damage.
Never test for gas leaks with an open flame.
Use a commercially available soap solution made
specifically for the detection of leaks to check all
connections. A fire or explosion may result causing
property damage, personal injury or loss of life.
RISQUE D'INCENDIE OU D'EXPLOSION
Si les consignes de sécurité ne sont pas suivies à la lettre,
cela peut entraîner la mort, de graves blessures ou des
dommages matériels.
Ne jamais vérifier la présence de fuites de gaz au moyen
d'une flamme nue. Vérifier tous les raccords en utilisant
une solution savonneuse commerciale conçue
spécialement pour la détection de fuites. Un incendie ou
une explosion risque de se produire, ce qui peut entraîner
la mort, des blessures ou des dommages matériels.
This furnace is manufactured for use with natural gas. It
appropriate L.P. conversion kit listed in the
of this manual
in
of this
manual.
Provide adequate combustion and ventilation air to the fur-
section of this manual.
-
section of this manual.
Always install a furnace to operate within the furnace’s
intended temperature-rise range with a duct system which
has external static pressure within the allowable range, as
of these instructions.
When furnace duct(s) supply air outside the space contain-
ing the furnace, a return air duct must terminate in the same
space as the supply duct and be sealed to the furnace casing.
-
of this manual.
This furnace may be used as a construction site heater only
if certain conditions are met. These conditions are listed in
the of this manual.
-
-
-