Service Manual

PRODUCT IDENTIFICATION

MODEL # MFG # DESCRIPTION

DCVK-20

(CVENT-2)

DCVK-30

(CVENT-3)

N/A

Concentric Vent Kit

. This kit is designed to allow terminations of a direct vent furnace

to be "concentrically" vented through a wall or roof. This kit allows a single penetration

to support terminations for both the vent/flue and the combustion air intake pipe.

EFR02

N/A

External Filter Rack Kit

. For use with 34.5" up flow gas furnaces. This kit is intended to

provide a location, external to the furnace casing for installation of a permanent filter.

The rack is mounted over the indoor air blower compartment area of either side panel,

and provide filter retention as well as a location for attaching return air ductwork.

0170K00000S

N/A

Side Wall Only Concentric Vent Kit

. This kit is to be used with 2" - 3" vent systems.

The vent kit must terminate outside the structure. This kit is NOT intended for use with

single pipe (indirect vent) installations.

0170K00001S

N/A

Side Wall Only Concentric Vent Kit

. This kit is to be used with 2" vent systems. The

vent kit must terminate outside the structure. This kit is NOT intended for use with

single pipe (indirect vent) installation

LPLP03

N/A

LP Gas Low Pressure Kit

. Designed for use with furnaces converted to LP gas. The kit

monitors gas line pressure with a pressure switch and will open the circuit to the gas

valve if the LP tank pressure gets low.

LPM-07

N/A

LP Conversion Kit

Converts a 34.5" single stage furnace to operate on L.P. gas. The

kit contains an L.P. gas valve and a set of six L.P. orifices.

RF000142

N/A

Drain Coupling Kit

For use when the drain/vent elbow has been removed in a

horizontal left installation. This kit prevents condensate from getting in the inducer and

routes the condensate to a drain.