GC9C96 Installation Manual
12
-
Condensate Drain Trap and Lines for
Refer to Horizontal Applications and Conditions - Drain Trap
and Lines.
POSSIBLE PROPERTY DAMAGE, PERSONAL INJURY OR DEATH MAY OCCUR
IF THE CORRECT CONVERSION KITS ARE NOT INSTALLED. THE APPROPRIATE
KITS MUST BE APPLIED TO ENSURE SAFE AND PROPER FURNACE OPERA-
TION. ALL CONVERSIONS MUST BE PERFORMED BY A QUALIFIED INSTALLER
OR SERVICE AGENCY.
-
Installation of this furnace at altitudes above 7000 ft (2134 m)
shall be made in accordance with the Listed High Altitude
Conversion Kit available with this furnace.”
L'installation de ce générateur de chaleur à des altitudes
supérieures à 7000 pi (2134 m) doit être effectuée
conformément aux instructions accompagnant la trousse de
conversion pour haute altitude fournie avec cet appareil.
For installations above 7000 feet, please refer to the furnace
-
HIGH STAGE LOW STAGE
#45 (1)
#50 (2)
LPM-08* (1) 1.25MM (1)
LPM-30* (2) #57 (2)
PRESSURE
SWITCH
(1) FOR USE WITH ALL MODELS EXCEPT *M9C960303AN
ALTITUDE
KIT
ORIFICE
MANIFOLD PRESSURE
3.5" w.c.
1.9" w.c.
*supports both Honeywell and White-Rodgers 2-stage valves
0 - 7000
PROPANE
NATURAL
NONE
GAS
10.0" w.c.
6.0" w.c.
NONE
NONE
(2) FOR USE WITH ONLY *M9C960303AN
UPON COMPLETION OF THE FURNACE INSTALLATION, CAREFULLY INSPECT
THE ENTIRE FLUE SYSTEM BOTH INSIDE AND OUTSIDE OF THE FURNACE TO
ASSURE IT IS PROPERLY SEALED. LEAKS IN THE FLUE SYSTEM CAN RESULT
IN SERIOUS PERSONAL INJURY OR DEATH DUE TO EXPOSURE TO FLUE PROD-
UCTS, INCLUDING CARBON MONOXIDE.