DFK Installation Instructions

5. Slowly and carefully, remove the paper backing from the
insulation adhesive and install down sides B and D. Take
care not to cause any tears in the insulation.
6. Fold over inside and outside tabs of sides B and D.
7. As side C is reached, fold over the inside of the drain pan
insulation and continue peeling the backing off the
insulation and adhering it to the drain pan. Fold over
remaining insulation to the outside of side C similar to
side A.
© 2013 Goodman Manufacturing Company, L.P.
5151 San Felipe, Suite 500, Houston, TX 77056
www.goodmanmfg.com -or- www.amana-hac.com
8. Add block off plate on side A of coil as shown in Figure 4.
9. Make sure the hole on the block off plate aligns with the
hole on the coil and secure the block off plate with two
provided screws as shown in Figure 4.
B
l
o
c
k
O
f
f
P
l
a
t
e
B
l
o
c
k
O
f
f
P
l
a
t
e
FIGURE 4 - Block Off Plate