Install Instructions

ManualsBrandsGoodman ManualsEvaporator Coils4 - 5 Ton, Cased Evaporator Coil (W 24-1/2 x D 21 x H 30)

Made in the USA by:

Goodman Manufacturing Company, L.P.

IO-236E 2550 North Loop West, Suite 400, Houston, TX 77092 06/06

www.goodmanmfg.com or amana-hac.com

All information contained herein is subject to change without notice.

INSTALLATION & OPERATING

INSTRUCTIONS FOR

UPFLOW/DOWNFLOW COILS

Summary of content (4 pages)

PAGE 1
INSTALLATION & OPERATING INSTRUCTIONS FOR UPFLOW/DOWNFLOW COILS All information contained herein is subject to change without notice. IO-236E Made in the USA by: Goodman Manufacturing Company, L.P. 2550 North Loop West, Suite 400, Houston, TX 77092 www.goodmanmfg.com or amana-hac.com © 2004-2006 Goodman Manufacturing Company, L.P.
PAGE 2
INDEX DANGER Introduction ............................................................ 2 IMMEDIATE HAZARDS WHICH WILL RESULT IN PROPERTY DAMAGE, PRODUCT DAMAGE, SEVERE PERSONAL INJURY OR DEATH. Replacement Parts ............................................... 2 Safety Instructions ................................................ 2 WARNING HAZARDS OR UNSAFE PRACTICES COULD RESULT IN PROPERTY DAMAGE, PRODUCT DAMAGE, SEVERE PERSONAL INJURY OR DEATH. Codes and Regulations .................................
PAGE 3
PLASTIC or BRASS CAP CAUTION IF SECONDARY DRAIN IS NOT INSTALLED, THE SECONDARY ACCESS MUST BE PLUGGED. 13/16" NUT TAILPIECE REFRIGERANT LINES WARNING PISTON WHITE TEFLON SEAL TO PROTECT THE UNIT WHEN WELDING CLOSE TO THE PAINTED SURFACES, THE USE OF A QUENCHING CLOTH IS STRONGLY ADVISED TO PREVENT SCORCHING OR MARRING OF THE EQUIPMENT FINISH. SOLDER WITH A MINIMUM OF 5% SILVER IS RECOMMENDED.
PAGE 4
If you install your uncased coil on top of a gas furnace the following is required: Typical drain pipe routings can be seen in Figure 5 to avoid interference with vent piping. Allow enough space between the top to the furnace and the bottom of the plastic coil drain pan to have a free flow of air. Drain Connection NOTE: The cased coil MUST be installed with the line set and drain opening to the FRONT of the furnace. There should be a minimum of 2.