ASPT Service Manual
Table Of Contents
- IMPORTANT INFORMATION
- PRODUCT IDENTIFICATION
- Checking Voltage
- Checking Wiring
- Checking Thermostat And Wiring
- Thermostat Wiring
- Checking Transformer And Control Circuit
- Checking Contactor And/Or Relays
- Checking Contactor Contacts
- Checking Fan Relay Contacts
- Checking Loss Of Charge Protector (Heat Pump Models)
- Checking High Pressure Control
- Checking Low Pressure Control
- Copeland Comfort Alertâ„¢ Diagnostics - 3-Wire module
- Copeland Coresenseâ„¢ Diagnostics - 3-Wire module
- Checking Capacitor
- Resistance Check Using A Digital Multi-Meter
- Capacitance Check Using A Digital Multi-Meter (In Capacitance Mode)
- Testing a Run Capacitor Under Load
- Checking Outdoor Fan and Blower Motors (PSC Motors)
- Checking Fan and Blower Motor (ECM Motors)
- Checking ECM Motor Windings
- ECM CFM Adjustments MBE/AEPF
- Blower Performance Data
- Checking High Efficiency Motors
- EEM Blower Replacement
- MBR/AR*F Electronic Blower Time Delay Relay
- Checking Compressor
- Resistance Test
- Ground Test
- Unloader Test Procedure
- Operation Test
- Checking 3-Phase Scroll Compressor Rotation
- Testing Crankcase Heater (Optional Item)
- Checking Reversing Valve and Solenoid
- Testing Defrost Control
- Testing Defrost Thermostat
- Checking Heater Limit Control(s)
- Checking Heater Elements
- Electric Heater (Optional Item)
- Checking Heater Limit Control(s)
- Checking Heater Elements
- Refrigeration Repair Practice
- Leak Testing (Nitrogen or Nitrogen-Traced)
- Evacuation
- Charging
- Checking Compressor Efficiency
- Overfeeding
- Underfeeding
- Checking Superheat
- Subcooling on Expansion Valve System
- Checking Expansion Valve Operation
- Checking Restricted Liquid Line
- Overcharge Of Refrigerant
- Non-Condensables
- Compressor Burnout
- Refrigerant Piping
- Duct Static Pressures
- Single Piece Air Handler External Static
- Two Piece Air Handler External Static Pressure
- Furnace External Static Pressure
- Periodic Maintenance
PRODUCT IDENTIFICATION
44
Model/Rev
Description
ASPT[24/36/48/60]*14 Introduction of new generation ASPT air handlers.
ASPT36C 14AB
ASPT[48/60]D14AB
ASPT48D 14AC
9mm return bend coil changes to new generation of ASPT air handlers.
ASPT24B 14AC
ASPT30C 14AB
ASPT36C 14AC
Programmed Broad Ocean Motor. The supplier can program the motor instead of furnace plant,
thus eliminating any programming installing issues. The programmed label will provide by
supplier.
ASPT[24, 36]B14AD
ASPT30C14AC
ASPT[42, 48] C14AB
X13 Motor IP changed to IGBT (Broad Ocean).
ASPT[42-48]C14AA
Initial release of models with 2+2 coil slab assy. These models are required to meet higher
tonnage rating in Cabinet.
ASPT42D 14AB
ASPT48D 14AD
ASPT60D 14AC
Nidec Pre-programmed Motor. Nidec motor can be programmed by the supplier instead of
programming at the furnace plant, thus eliminating any programming installing issues.
ASPT[25,29,37] B14AA
ASPT[37,47, 59] C14AA
ASPT[47, 49, 61] D14AA
Initial release of models with a 2 slab, low airflow resistant coil with a fixed speed ECM 53"
cabinet size. ASPT42C and aspt48C 2+2 models discontinued.
ASPT33C14AA
ASPT39C14AA
ASPT49C14AA
Upgrade the current ASPT C-49 cabinets to include 1. quality improvements captured in
Ready15 design. 2.include redesigned drain pan, Morrison blower housing and Emerson NXT
Booster Charge AdjustableTXV.
ASPT35B14AA Introducing 2.5 and 3 Ton Air Handler product lines.
ASPT[33,37,39,47,49,59]C14AB
ASPT[47,49,61]D14AB
Revisions because of New Heater kits released
ASPT[25,29,37,]B14AB
ASPT[33,37,39,47,49,59]C14AC
ASPT[47,49,61]D14AC
Air handler revisions due to using an upgraded (thicker with higher R value)
Quietflex wrapper insulation.
ASPT[33,39,47]BA
Revision change on ASPT33C14/39C14/47C14 air handlers to change the amps in electrical
data which ends reducing the MOP size from 35 to 30 and thus increasing wire gauge size in
the field for the 5kW heater kit
ASPT35B14AB
The SR plate format is changing from SR075 to SR099 and in order to track this change a
minor revision is necessary.
ASPT
A- SINGLE PIECE AIR HANDLER S-MULTI-POSITION EEM MOTOR PAINTED TXV