User's Manual

3.5MM

Audio Cable

HOLD

Audio Connector Jack for

Headphone/external Speaker

USING THE PORTABLE SPEAKERS

To use the External Speaker function, please follow this procedure;

1] Disconnect the fixed audio cable from the

headband and both of the earcups.

2] Remove the earcups from the headband by carefully

pulling them away from the Headband housing.

3] When the earcups are disconnected from the headband,

use the provided 3.5mm audio cable to connect the

left and right earcup speakers together through the

fixed audio cable ports on the top of the earcups.

4] To enable the External Speaker Mode, hold the multi-function

button for 2 Seconds. To change back to headphones

mode hold the multi-function button for 2 Seconds.

CHARGING THE HEADPHONES

1] To charge the Headphones, use the supplied USB cable and insert into

any powered USB Port. Normal charging process takes 2-3 hours.

2] The red LED on the left Earcup will turn on when charging

and will turn off when charging is complete.

3] Make sure the battery has been fully charged and fully released

at the first three times of use to ensure the battery the best

performance. After charging is complete, please remove the cable

from the Headphones and the USB Cable from the USB port.

Do not keep the Headphones connected to the USB port for a long time

when charging complete as this will shorten the lifetime of the Battery.