User Manual

User Manual

Model: TM51010

FCC ID: SW8TM51010

Overview

TM51010 Wireless Module is a powerful, generic Wi-Fi/BLE Board based on highly integrated Realtek RTL8720DN and

Nordic nRF52832 module with built-in security features and ultra-low power consumption. The embedded system

product developers and device makers can now drastically shorten their development cycle and reduce time to market

by using this Wi-Fi & BLE M.2 Wireless Module.

Features

 IPEX antenna design for Wi-Fi and BLE to ensure better RF performance

 Wi-Fi MCU with Amazon FreeRTOS to support Cloud service securely

 Android SDK of BLE Mesh ready for fast installation and via Smartphone to ensure better user experience

 Multi-Threading optimization to speed up network distribution process by saving time 1.5x than SIG Mesh

Specifications

Wi-Fi

Network Standards IEEE 802.11 a/b/g/n 1x1

Operating Frequency 2.4GHz & 5GHz

Data Rate Up to 150Mbps

Antenna IPEX connector for external antenna

Bluetooth LE

RF Protocol BLE SIG Mesh

Operating Frequency 2.4GHz

Operation Range 30m (indoor open space)

Antenna IPEX connector for external antenna

M.2 Interface

VCC support 3.3V

USB x1

I2C x1

PAGE 1
User Manual Model: TM51010 FCC ID: SW8TM51010 Overview TM51010 Wireless Module is a powerful, generic Wi-Fi/BLE Board based on highly integrated Realtek RTL8720DN and Nordic nRF52832 module with built-in security features and ultra-low power consumption. The embedded system product developers and device makers can now drastically shorten their development cycle and reduce time to market by using this Wi-Fi & BLE M.2 Wireless Module.
PAGE 2
x15 GPIO Others Dimensions (L x W x H) 45 x 32 x 5.8mm Operating Temp. -20°C to +85°C Module installation 1. Insert the module into the M.2 slot of the end product motherboard. (Figure 1) 2. Secure the module to the motherboard with screw.
PAGE 3
FCC Statement This device complies with Part 15 of FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC Caution The user that changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. FCC Radiation Exposure Statement 1.