User's Manual

9
Operation
Inclusion
Note: Make sure a Z-Wave
®
remote controller has been
installed and included to an available Z-Wave
®
network
before joining the Z-Wave
®
Window/Door Detector.
Not all Z-Wave
®
enabled remote controllers have the same
installation process. Actual instructions may vary, it depends
on the software that Z-Wave
®
controller provided.
1. Before starting the inclusion process, be
sure the DIP switch is setup to the default.
To switch the DIP, refer to DIP switch
chapter.
2. Press the <Program> button 3 times within 2 seconds on
the Z-Wave
®
Window/Door Detector to include a Z-Wave
®
network. LED fl ashes green during the inclusion process.
3. Once the Z-Wave
®
Window/Door Detector has been
detected, the LED will stop fl ash, and the detected
information will be displayed on the controller's panel or
utility software.
Default
setting