User's Manual

Installation

Before installing the Z-Wave

Window/Door Detector, make

sure the Detector has been included to a Z-Wave

network.

Internal connection

1. Adjust the dip switch to the

default. Refer to Dip switch

chapter for more details.

2. Mount the Z-Wave

Window/

Door detector to a window or

door following the previous

section.

3. Install the contact magnet to the moving part of the

window or door opposite to the detector. Make sure the

window or door is closed when installing.

Note: For better performance, make sure the gap between

detector and contact magnet is less then 10mm.