User's Manual

19
Dip switch
The Z-Wave
®
Window/Door detector can be setup to internal
or external connections. Follow the steps below to adjust
the dip before installing the detector to a door or window.
1. Loosen the screws from the rear panel, and then remove
the cover.
2. Adjust the dip switches using a fi nger or fi nger nail
according to the desired connection of the Window/Door
detector.
Default or Internal connection
Note: Adjust the dip switches to
default before including or excluding
the detector to a Z-Wave
®
network.
External connection
External and Internal mixed connection