User's Manual

5
Product Description
Below is a description of button, light and plugs for the Z-Wave Window / Door
Detector.
LED
The light will blink to indicate that the module has been entered “Program Mode”
or when it is communicating wirelessly to the Z-Wave controller, such as Z-Wave
Dongle.
Contact Magnet
The magnet is used to detect if the window or door are open. Magnetic contact is
placed next to the Window / Door Detector.
Program Button
Pressing this button down will put the Z-Wave Window / Door Detector into
“Program Mode”.
Battery Lid Screw
Located on the back of the Window / Door Detector, the battery lid is fastened by
the battery lid screw on the bottom of the unit. Remove this lid to install the
batteries for the Window / Door Detector.