User's Manual

8
Installation Requirements
To install this product you must have Z-Wave enabled controller, such as
Z-Wave Dongle, to make an association with Z-Wave Window / Door Detector.
Installing the Z-Wave Window / Door Detector
NOTE =======================================================
Before you install or use this Z-Wave Window / Door Detector, please install
your Z-Wave controller first and make an inclusion for your Z-Wave device. Not
all Z-Wave enabled remote controls have the same installation process. Actual
instructions may vary, it depends on the software that Z-Wave controller
provided.
============================================================
To install the batteries
1. Use your screwdriver to open the battery lid.
2. Slide the battery lid down and insert your 2*AAA batteries into the Z-Wave
Window / Door Detector according to the instructions in the battery
compartment.
3. Slide the batter lid back on the Z-Wave Window / Door Detector and fasten
the lid by using the screw.