User's Manual

Installing the Power Switch

NOTE =======================================================

Before you install or use this Power Switch, please install your Z-Wave



controller first and make an inclusion for your Z-Wave



device. Not all Z-Wave



enabled remote controls have the same installation process. Actual instructions

may vary; it depends on the software that Z-Wave



controller provided.

============================================================

1. Please plug the Power Switch into an available wall outlet near

the load to be controlled in your desired location of your office or home.

2. Operate your control panel from Z-Wave



controller to include the Power

Switch in your network.

3. Once the Power Switch has been included in your network, you may see

or get some information about your Power Switch on your control panel

or else to confirm that has been added. If not, try the process again or try

deleting this switch from Z-Wave



controller first.

4. When the Power Switch has been added into Z-Wave



control panel

successfully, you will need to configure it to a specific button or other else on

your control panel. Refer to your Z-Wave



control panel for instructions on

how to do this.

5. Now you can plug your electric device into the Z-Wave



enabled outlet on

the Power Switch and control your device on or off via your own PC.