User's Manual

Product Description
Below is a description of button, light and plugs for the Power Switch.
Z-Wave

Enable Outlet
This outlet is a socket where the device or equipment you wish to control should
plug into, such as LCD monitor. Note that any device plugged into this outlet
must NOT exceed 1500 watts.
LED
The light will blink to indicate that the module has been entered “Program Mode”
or when it is communicating wirelessly to the Z-Wave

controller (i.e. Z-Wave

Dongle).
Switch Button
When the Power Switch has been installed, pressing the switch button will
manually turn the attached device on or off.
When primary controller is waiting for inclusion or exclusion to setup Z-Wave

Network, please press this button could add or remove this device from Z-Wave

network.
Wall Outlet Plug
Located on the back of the Power Switch, the plug is used to plug your
module into an available wall outlet in your home or office.
Installation Requirements
To install this product you must have Z-Wave

enabled controller, such as
Z-Wave

Dongle, to make an association with Power Switch.
5