Certifications 2

Safety data sheet according to Regulation (EC) No 1907/2006, Annex II
Revision date / version: 02.10.2018 / 0001
Replacing version dated / version: 02.10.2018 / 0001
Valid from: 02.10.2018
PDF print date: 04.10.2018
Cleaning wipes in dispenser box, 100pcs
Consumer Human - oral Long term, systemic
effects
DNEL 33 mg/kg
bw/day
Consumer Human - oral Long term, systemic
effects
DNEL 78 mg/kg
bw/day
Consumer Human - inhalation Short term, local
effects
DNEL 553,5 mg/m3
Consumer Human - dermal Long term, systemic
effects
DNEL 50,6 mg/kg
Consumer Human - inhalation Long term, systemic
effects
DNEL 369 mg/m3
Workers / employees Human - dermal Long term, systemic
effects
DNEL 18,1 mg/kg
Workers / employees Human - inhalation Long term, systemic
effects
DNEL 43,9 mg/m3
Workers / employees Human - oral Long term, systemic
effects
DNEL 3,3 mg/kg
Workers / employees Human - oral Long term, systemic
effects
DNEL 183 mg/kg
bw/day
8.2.1 Appropriate engineering controls
Ensure good ventilation. This can be achieved by local suction or general air extraction.
If this is insufficient to maintain the concentration under the WEL or AGW values, suitable breathing protection should be worn.
Applies only if maximum permissible exposure values are listed here.
Suitable assessment methods for reviewing the effectiveness of protection measures adopted include metrological and non-
metrological investigative techniques.
These are specified by e.g. BS EN 14042.
BS EN 14042 "Workplace atmospheres. Guide for the application and use of procedures for the assessment of exposure to
chemical and biological agents".
8.2.2 Individual protection measures, such as personal protective equipment
General hygiene measures for the handling of chemicals are applicable.
Wash hands before breaks and at end of work.
Keep away from food, drink and animal feedingstuffs.
Remove contaminated clothing and protective equipment before entering areas in which food is consumed.
Eye/face protection:
Normally not necessary.
Skin protection - Hand protection:
Normally not necessary.
Skin protection - Other:
Normally not necessary.
Respiratory protection:
Normally not necessary.
Thermal hazards:
Not applicable
Additional information on hand protection - No tests have been performed.
In the case of mixtures, the selection has been made according to the knowledge available and the information about the contents.
Selection of materials derived from glove manufacturer's indications.
Final selection of glove material must be made taking the breakthrough times, permeation rates and degradation into account.
Selection of a suitable glove depends not only on the material but also on other quality characteristics and varies from manufacturer
to manufacturer.
In the case of mixtures, the resistance of glove materials cannot be predicted and must therefore be tested before use.
The exact breakthrough time of the glove material can be requested from the protective glove manufacturer and must be observed.
8.2.3 Environmental exposure controls
No information available at present.
SECTION 9: Physical and chemical properties
9.1 Information on basic physical and chemical properties
Page 4 of 11