Manual

TS200 / TS250
Translation of the original operating instruction and spare parts list
- 27-
5007090-00
BA-E
®
• Start the machine.
• Put your hand on the cutting handle.
• Push the cutting table slowly and without undue pressure towards the rotating blade. The blade
cuts the applied material.
To put the cutting head back in the normal position, please follow this procedure:
• Switch off the machine and make sure the blade is not
rotating.
• Tighten well the two grip knobs on each side of the machine.
• Rotate the cutting head until it stops at 0°.
• Tighten well the two grip knobs on each side of the machine.