Manual

TS200 / TS250
Translation of the original operating instruction and spare parts list
- 26-
5007090-00
BA-E
®
• Rotate the complete cutting head and rail to the required
angle.
• Tighten well the two grip knobs on each side of the machine.
• Loosen the adjusting handle.
• Adjust the depth stop and tighten it well.
• Make sure that the blade is not touching the cutting table at
any position of the cutting table when the cutting head is at
the lowest position.
• Put the material on the cutting table. By using the back
square control the position of the material.