Manual

TS200 / TS250
Translation of the original operating instruction and spare parts list
- 22-
5007090-00
BA-E
®
5.3.1 Cutting method: Fixed depth cutting
In fixed depth cutting, the cutting head is locked in a fixed position. To do fixed depth cutting, please
follow this procedure:
• Switch off the machine and make sure the blade is not rotating.
• Loosen the adjusting handle
and adjust the cutting head
to the desired position.
• Make sure that the blade is not touching the cutting table at any
position of the cutting table or cutting head.
Warning: Never touch rotating parts!
Attention: Transport the unit only when the engine is stopped! This applies also to
a short change of location!
Attention: Wear appropriate individual protective equipment!