Operation Manual

135
rogramación de los teléfonos T-740 Plus.
P
Toshowthatthesystemisreadyforprogramming,
thedoorpanelandthetelephone'shandsetwill
reproduce a tone (the telephone led will light).
Audiocommunicationcanbeestablished.
Press the door panel push button that will call to
this telephone. At this moment both door
panel and handset will reproduce tones (the
telephoneledwillslowblink).
ToprogrammthetelephoneasMaster,pressthe
h (thetelephoneledwilloff).
Closethetelephone.
ookswitch
Set to ON the switch number 2 of the SW2 configuration dip switch, placed at
the upper left side (back) of the sound module. The door panel will reproduce a
soundtoadvise thatthesystemhasenteredintoprogramming mode.Insystems
with more than one door panel, the programming process shall be done on the
masterdoorpanelonly.
Each apartment must have one master unit only; in case of parallel units configure them as slaves,
bothmonitorsortelephones.
Makeacalltocheckthat thetelephone hasbeen succesfullyprogrammed. Repeat
thesestepstoprogramtherestoftelephones.
Once the programming has been finished, set to OFF the programming switch. If
you don't, the door panel will reproduce a tone to advise that the system is still
intoprogrammingmode.
To programm the telephone as Slave, press the
P1 door release push button (the telephone
led will quick blink) and later press the hook
switch(theledwilloff).
Closethetelephone.
Open the telephone to programming (see page
134). Select in the SW1 dip switch the fuction
mode for the auxiliary
(see page 133) and later press the P3
programmingpush-button.
function push button
To programm the telephone as Slave +
Intercom., press the P2 auxiliary function
push button (the led will quick blink) and later
pressthehookswitch(theledwilloff).
Closethetelephone.
Toprogramthetelephonefromageneraldoorpanel(ifitexists),seepage119.
TELEPHONES PROGRAMMING
P3
1 2
P3
ON
P3
ON
P3
ON
P3
ON
P3
SW1
1 2
P1
P2
CN1
M
S
SI
P1
P2
CN1
P3
SW1
P1
P2
CN1
ON
P3
ON
P3
SW1
P1
P2
CN1
ON
P3
SW1
P1
P2
CN1
ON