Operation Manual

133

unction push buttons

TELEPHONE DESCRIPTION

If the handset is on the craddle sends a panic call to the porter's

exchanges that have enabled the reception of this type of call. If not,

allows to call to the master porter's exchange. During call reception

andcommunicationprogressesallowsthelockreleaseactivation.

Auxiliary function push button, depending on setting in the SW1 dip

switch will realize one of the following functions: Autoswitch-on, "PA"

output,calltoaslaveporter'sexchangeandintercommunication.

escription of configuration dip switch.

escription of programming push button.

Factory default

"Autoswitch-on"mode:switches1and2toON.

With the handset off the cradle, allows to stablish audio communication with the

door panel that has been configured with the autoswitch-on function. This

functionisdisabledifacommunicationisalreadyestablished.

"PA" output mode: switches 1to ON and 2 to OFF:

Regardlessofthehandset'sposition,itactivatesthe"PA"telephoneoutput.

"C "mode:switches1toOFFand2toON.

With the handset off the cradle, allows to call to a porter's exchange that it is

configuratedasslave.

alltoaslaveporter'sexchange

" "mode:switches1and2toOFF.

Withthe handset off the cradle, allows to make an intercom call between two units

ofthesameapartment.

Intercommunication

The P3 programm push button is located in the top part left of the circuit,it is

accessed by opening the telephone. Allows to telephone enter in programming

modewiththedoorpanel,(seeprogrammingprocessonpage135).

IMPORTANTE: Select before programming the telephone.the auxiliary function push button mode

The SW1 configuration dip switch is located in the top part left of the circuit,it is

accessed by opening the telephone and allow the next operation modes for the

auxiliaryfunctionpushbutton:

SW1