Operation Manual

131
TELEPHONES PROGRAMMING
rogramming the T-940 Plus telephones.
P
Switch off the telephone to be programmed.
Once the telephone is off, press the door release push button.
Setto ONtheswitchnumber2oftheSW2configurationdipswitch,placed
at the upper left side (back) of the sound module. The door panel will
reproduce a sound to advise that the system has entered into
programmingmode.
In systems with more than one door panel, the programming process shall
bedoneonthemasterdoorpanelonly.
Toprogramthetelephonefromageneraldoorpanel(ifitexists),seepage119.
To show that the system is ready for programming, the door
panelwill reproduceatoneandthetelephoneledwillblink.
At this moment, the door release push button can be
released.Liftthe handset toestablishaudiocommunication
withthedoorpanel.
With the door release push button pressed switch on the
telephone.
Pressthedoorpanelpushbuttonthatwillcall
to this telephone. At this moment the door
panel will reproduce a tone and the
telephoneledwillblink.
Toprogramthetelephoneasmaster,switchit
offandonagain.
Toprogramitasslave,pressthedoorrelease
pushbutton.
Toprogramit as slavewithintercom function
pressthecenterpushbutton.
Each apartment must have one master unit only; in case of parallel units configure them as
slaves,bothmonitorsortelephones.
Make a call to check that the telephone has been succesfully programmed.
Repeatthesestepstoprogramtherestoftelephones.
Once the programming has been finished, set to OFF the programming
switch. If you don't, the door panel will reproduce a tone to advise that the
systemisstillintoprogrammingmode.