Operation Manual

128
MONITORS PROGRAMMING
rogramming the Platea Plus / Tekna Plus monitors.
P
Setto ONtheswitchnumber2oftheSW2configurationdipswitch,placed
at the upper left side (back) of the module EL631/Plus. The door panel
will reproduce a sound to advise that the system has entered into
programmingmode.
In systems with more than one door panel, the programming process shall
bedoneonthemasterdoorpanelonly.
Toprogramthemonitorfromageneraldoorpanel(ifitexists),seepage119.
Switchoffthemonitortobeprogrammed.
Oncethemonitorisoff,pressthedoorreleasepushbutton.
With the door release push button pressed switch on the
monitor.
To show that the system is ready for programming, the door
panel will reproduce a tone and the picture will appears
on the monitor. At this moment, the door release push
buttoncanbereleased.Lift the handset to establish audio
communicationwiththedoorpanel.
Press the door panel push button that will
call to this monitor. At this moment the
door panel will reproduce a tone and the
monitorledwillblink.
To program the monitor as master, switch it
offandonagain.
To program it as slave, press the door
releasepushbutton.
To program it as slave with intercom
functionpressthe pushbutton.
Eachapartmentmusthaveonemasterunitonly;incaseofparallelunitsconfigurethemasslaves,
bothmonitorsortelephones.
Make a call to check that the monitor has been succesfully programmed.
Repeatthesestepstoprogramtherestofmonitors.
Once the programming has been finished, set to OFF the programming
switch. If you don't, the door panel will reproduce a tone to advise that the
systemisstillintoprogrammingmode.