Manualshelf

Operation Manual

ManualsBrandsGolmar ManualsIntercomsT631 Plus Nexa
11121314151617181920
118
GENERAL DOOR PANEL INSTALLATION
Define a backbone code to program with dip switches Sw2-4 to Sw2-
10. Set a code between 1 and 120. To set the code use binary
coding,(seepage116).
Pressthegeneraldoorpanelpushbuttonthatiswishedhasthis
backbone code. At this momentthe general door panel will
reproduceatone, confirming thatthepushbutton hasbeen
succesfullyprogrammed.
Repeat these steps to program the rest of push buttons. Once the programming has been finished,
set to OFF the programming switch. If you don't, the general door panel will reproduce a tone to
advisethatthesystemisstillintoprogrammingmode.
Programming the push button (with a monitor/telephone code):
This programming mode allows to assign a monitor/telephonecode to push button of the general
doorpanel.
Locate the SW2 configuration dip switch of the general door
panel to program, placed at the upper left side (back) of the
sound module. With the switches 1 and 3 to ON, set the
switch 2 to ON: to show that the system is ready for
programming,thegeneraldoorpanelwillreproduceatone.
Pressthegeneraldoorpanelpushbuttonthatiswishedhasthis
monitor/telephone code. At this moment the general door
panelwillreproduceatone,confirmingthatthepushbutton
hasbeensuccesfullyprogrammed.
Repeat these steps to program the rest of push buttons. Once the programming has been finished,
set to OFF the programming switch. If you don't, the general door panel will reproduce a tone to
advisethatthesystemisstillintoprogrammingmode.
Define a monitor/telephone code to program with dip switches Sw2-4
to Sw2-10. Set a code between 1 and 120. To set the code use
binarycoding,(seepage116).
Programming the push button ( ):with a backbone code
Thisprogrammingmodeallowstoassignabackbonecodetopushbuttonofthegeneraldoorpanel.
Locate the SW2 configuration dip switch of the general door
panel to program, placed at the upper left side (back) of the
sound module. Withtheswitch 1 to ON and 3 toOFF, set the
switch 2 to ON: to show that the system is ready for
programming,thegeneraldoorpanelwillreproduceatone.