Operation Manual

117
ConfiguretheEL631/Plus ofthegeneraldoorpanelinEL501mode,(seepage115).module
Locate the SW2 configuration dip switch of the general door
panel to program, placed at the upper left side (back) of the
sound module. With the switches 1 and 3 to OFF, set the
switch 2 to ON: to show that the system is ready for
programming,thegeneraldoorpanelwillreproduceatone.
Pick up the monitor/telephone handset of
the apartment to program and press the
doorreleasepushbuttonuntiltoestablish
communication of audio with the general
doorpanel.
Press the general door panel push button that will call to this
monitor or telephone. At this moment the general door
panel will reproduce a tone. To finish the push button
programmation, replace the monitor/telephone handset;
to show that the push button has been succesfully
programmed,thegeneraldoorpanelwillreproduceatone.
Make a call to checkthat the push button has been succesfully programmed.
Repeatthesestepstoprogramtherestofpushbuttons.
Once the programming has been finished, set to OFF the programming
switch. If you don't, the general door panel will reproduce a tone to advise
thatthesystemisstillintoprogrammingmode.
eneral door panel (programming modes).
G
Thisprogrammingmodeallowstoassignamonitor/telephone(programmed)tothepushbuttonof
thegeneraldoorpanelthatitwishestocall.
Before the monitors/telephones of the inner door panel/s must be programmed, see page 128
(monitors),131and135(telephones).
IMPORTANT: Before programming the general door panel push buttons, switch off the porter's
exchange(ifexists).
Programming the push button (by call of monitor/telephone):
T-940Plus T-740Plus
Thegeneraldoorpanelpermitsthefollowingprogrammingmodes:
O Programmingthepushbutton(bycallofmonitor).
O Programmingthepushbutton(withabackbonecode).
O Programmingthepushbutton(withamonitor/telephonecode).
O Programmingthemonitor/telephone.
rogramming the push buttons of the general door panel.
P
GENERAL DOOR PANEL INSTALLATION