Operation Manual

116
DOOR PANEL INSTALLATION
inary coding of the SW2 configuration dip switch
B
the sound module.
of
The switches set to OFF have null value. The values of the switches
set to ON are shown in the enclosed chart.
The backbone code will be calculated as the sum result of the
switches values set to ON.
Example: 64+0+16+0+4+2+1=87
Switch number:
ON value:
4
64
5
32
6
16
7
8
8
4
9
2
10
1
escription of the SW2 configuration dip-switch of
D
the sound module.
Allows to activate the autoswitch-on function (audio-video communication
withoutpreviouscall)atthedoorpanelthathasthisswitchtoONposition.
In systems with several door panels activate this function only in one of
them; in systems with general door panel this function can be activated in
onedoorpanelofeachinnerbackbone(building).
SettoONformonitorortelephonesprogramming.Oncetheprogramming
progress is finished return the switch to OFF position. The programming
processisdescribedonpages128(monitors),131and135(telephones).
In general door panel (EL501 mode), set to ON for general door panel
push buttons programming or backbone (building) monitor/telephones.
The programming process is described on pages 117 to 119. Once the
programmingprogressisfinishedreturntheswitchtoOFFposition.
SettoOFFincaseofamasterdoorpanel.Eachsystemmusthaveonlyone
masterdoorpanel;therestmustbeslaves(ON).
In systems with general door panel, set as master one door panel of each
inner backbone (building) and the general door panel as slave. Of this
way,theuserwillbeabletodistinguishsincedoorpanelarecallinghim.
Switches number 4 to 10 set the building code. In backbones with several
door panels, set the same code in all the panels; in systems with general
door panel, set different codes for each inner backbone (building). Set a
code between 1 and 120 for inner backbones (up to 127 with coded
panel) and a code 0 ( ) for general door panel/s. Toset the
codeusebinarycodingasshownonthenextparagraph.
Factory default
Factory default
The SW2 configuration dip-switch is located at the upper left
sideofthebackofthemodule.
For dip switch settings,
use the tool that is supplied with the
soundmodule.