Installation Instructions

ManualsBrandsGolmar ManualsIntercomsPlatea Plus

AWD154 Rev. 1 (05/2011)

42 Central Drive, Farmingdale NY 11735-1202

(631) 777-5500 Fax: (631) 777-5599

TOLL-FREE Technical Line 1-800-666-4800

Email:info@alphacommunications.com

Typical INSTALLATION WIRING MANUAL

for the Golmar Platea Plus (B&W or COLOR)

and/or SZENA (COLOR) Video-Intercom System

using CAT5 +2 Power Wires

NOTE: This manual is

intended to give basic system

block wiring information only.

It is not a complete system

installation and/or use or

programming manual.

For complete system wiring,

programming and use

information please see the

complete system manual for

your particular system

configuration.

Summary of content (7 pages)

PAGE 1
NOTE: This manual is intended to give basic system block wiring information only. It is not a complete system installation and/or use or programming manual. For complete system wiring, programming and use information please see the complete system manual for your particular system configuration. 42 Central Drive, Farmingdale NY 11735-1202 (631) 777-5500 Fax: (631) 777-5599 TOLL-FREE Technical Line 1-800-666-4800 Email:info@alphacommunications.
PAGE 2
NOTES: 1. Video monitors shown can be Platea Plus, Tekna Plus or Szena type (inter-mixed is OK). 2. All monitors at the end of each line must have the terminating resistor in place. 3. Model D6L-PLUS/2H multi-output video distributor/splitter shown to feed horizontal risers/lines. 4. Typical digital-dial or pushbutton type video door entry station (digital model shown on diagram). 5. Note wiring required between multiple video door entry stations (2 shown). 6.
PAGE 3
NOTES: 1. Video monitors shown can be Platea Plus, Tekna Plus or Szena type (inter-mixed is OK). 2. All monitors at the end of each line must have the terminating resistor in place. 3. Terminal connections shown may not be in the actual order they appear on the equipment.
PAGE 4
NOTES: 1. Video monitors shown can be Platea Plus, Tekna Plus or Szena type (inter-mixed is OK). 2. All monitors at the end of each line must have the terminating resistor in place. 3. This diagram is used in conjunction with the one on page 2. 4. This diagram is a typical diagram only and may not be the actual diagram for your application 5. Terminal connections shown may not be in the actual order they appear on the equipment. 6.
PAGE 5
NOTES: 1. Video monitors shown can be Platea Plus, Tekna Plus or Szena type (inter-mixed is OK). 2. All monitors at the end of each line must have the terminating resistor in place. 3. Terminal connections shown may not be in the actual order they appear on the equipment.
PAGE 6
NOTES: 1. Video monitors shown can be Platea Plus, Tekna Plus or Szena type (inter-mixed is OK). 2. All monitors at the end of each line must have the terminating resistor in place. 3. Terminal connections shown may not be in the actual order they appear on the equipment.
PAGE 7
NOTES: 1. Jumper on EL562 PC board shown when monitor IS NOT at the end of a riser/line. 2. Jumper on EL562 PC board shown when monitor IS at the end of a riser/line. 3. Monitors shown are Platea Plus type. 4. Terminal connections shown may not be in the actual order they appear on the equipment. 5. For actual system programming instructions and other wiring details and connections please see the actual system installation manual for the system you have purchased.