Operation Manual

136
ix the telephone.
F
It will be necessary to open the telephone for wiring and
fixing purposes. To open the telephone insert a plain
screwdriver into the slots and rotate it as shown.
Avoid to place the telephone near to
heating sources, in dusty locations or
smoky environments.
The telephone can be fixed using an
electrical embedding box or directly
on the wall, as shown on the picture.
If the telephone will be installed directly
over the wall, drill two holes of Ø6mm.
on the specified positions, using 6mm.
wallplugs and Ø3,5 x 25mm. screws.
Pass the installation wires through the corresponding hole and
connect them as shown on the installation diagrams.
Close the telephone as shown on the picture. Once the telephone
is closed, connect the handset using the telephone cord and
put it on the craddle.
PLATEA TELEPHONE DESCRIPTION TELEPHONES PROGRAMMING
rogramming the telephones.
P
golmar
13:15
In case of a general entrance door panel, program the telephones only from each internal
building door panel, as described on the corresponding instruction manual.
If this door panel is installed on an internal building of a residential complex or on a single
building, program the telephones as follows:
To enter the door panel into program mode, press
key symbol and enter the installer PIN code
(factory default: 1315), as described on page 114.
Switch off the telephone to be programmed.
Once the telephone is off, press the door release push button.
With the door release push button pressed
switch on the telephone.
To program the telephone as master,
switch it off and on again.
To program it as slave, press the door
release push button.
To program it as slave with intercom
function press the center push button.
O.K.
01
Each apartment must have one master unit only; in case of parallel units configure them
as slaves, both monitors or telephones.
Enter the code that will be used to call to
this telephone and press the key.
At this moment the panel will reproduce
a sound and the telephone led will blink.
To show that the system is ready for programming, the panel
will reproduce a sound and the LCD will display the
message program mode. At this moment, the door
release push button can be released. Lift the handset
to stablish audio communication with the door panel.
Only for T-940 Plus telephones:
137