Operation Manual

128
L562 module for video installations with twisted pair cable.
E
hanging the front film.
C
andling the end of line jumper.
H
The end of line jumper is placed on the CN4 connector (
CN2 in Platea Uno), that can be located on the monitor base.
In case of twisted pair cable installations, the end of line jumper
is placed in the EL562 module, also located in the CN4 connector
(CN2 in Platea Uno) of the monitor base.
Do not remove the jumper on monitors where the video cable finish.
Remove the jumper on monitors where the video cable continue.
The Platea Plus monitor is supplied with a reversible front film, that allow the owner
to choose between two colors.
To change the front film, remove the front plate by inserting a plain screwdriver
in the triangle marks, as it is shown on the drawing.
MONITOR ADJUSTMENTS
In Platea Plus: Locate the CN4 connector, that's placed in the
monitor base. Remove the existing jumper and plug the EL562
module.
In Platea Uno: Locate the CN2 connector, that's placed in the
monitor base. Remove the existing jumper on the connector and the
JP1 jumper on the right, then plug the EL562.
NOTE: on this type of installations the EL560 module must be
plugged in the CN6 connector of the keypad module (page 104).
Refer to the specific installation diagram.
129
Platea Plus: terminals +, – and Malla (shield) are duplicated for easiest cascade installation of
parallel monitors or telephones. If the first monitor is not placed on the connector, cascade
units will not be powered.
escription of the RCPL-Plus / RCPL-Uno monitor connector.
D
a. Wall attachment hole (x4).
b. Monitor attachment hook (x2).
c. Vertical wiring input.
d. Attachment clip.
e. Wiring input hole.
f. Installation terminals:
MONITOR CONNECTOR DESCRIPTION
Vin
Vout
Malla
Shield
Malla
Shield
A
HZ-
INT
SA
CTO
2C
A1
VP
MP
D
REF
RCPL-PLUS
LOTE
CODE 11758882
Colocar la parte superior de la regleta a 1,60m. del suelo.
Place the top part of the monitor connector at 1,60m. from the floor.
50mm.
50mm.
Presionar para abrir.
Press to open.
a
b
b
f
e
d
c
For both models
+, –: positive, ground.
Malla: coaxial shield.
A : audio communication.
D : digital communication.
HZ- : door bell push button input.
Platea Plus
Vin : video signal coaxial input.
Vout : video signal coaxial output.
INT : intercom.
SA : auxiliary calling device output.
CTO : video distributor activation output
2C : 2nd camera activation output.
A1 : optional device activation output.
Vp, Mp : twisted pair video signal.
Platea Uno
Vin / MP: video signal coaxial input.
twisted pair video signal MP input.
Vo / VP : video signal coaxial output.
twisted pair video signal VP input.
a