Owner's manual

Hard-Wired Remote Controls

The remote control has Red (+) and Black (-) power leads for the camera

system. It is recommended that these be joined using the appropriate auto-

motive or marine grade wire attachments. Each remote needs to be wired on

a single dedicated circuit and the power be fused at a minimum of 5 amps. It

is also recommended that the power wire be connected to an ignition circuit

or a separate on/off toggle between the camera and power source. Once the

power leads are attached, the 20’ wire harness needs to be attached to the

appropriate 2 and 4 pin connectors to connect with the camera.

The 25’ BNC Cable includes a BNC to RCA adapter for adaptation to a wide

variety of displays. The BNC cable needs to be attached and locked into the

camera’s BNC jack and then run to the display that is used. *Note: If a display

is included, please see the instructions for mounting and wiring the display.

Display and Camera must be wired to separate power circuits for proper

installation. See “Attaching the camera to the mounting plate” on page 8