Owner's manual

9
over the front of the mounting plate. First pull the camera backwards, then
seat the back of the camera on to the mounting plate. Displace the back of
the gasket, line up the hole and install the vise screw (provided). Tighten the
vise screw using a Phillips head screwdriver. Replace the gasket to finalize
the installation.
Wireless Remote Controls:
The wireless remote control units included are one dash mount and one
hand-held. They use buttons to perform the on/off and pan/tilt functions of
the camera. All systems have a main on/off switch for the camera itself. It
is suggested that the Helios camera be turned off until it is needed; this will
save power consumption and unnecessary draw on the battery. There are
also buttons for fast/slow operation of the pan/tilt mechanism of the system.
The Turtle Button is the slow function and the Rabbit Button is the faster func-
tion for the camera. To install the dash mounted wireless remote, remove the
cover and install four screws into the mounting holes and replace cover. The
On/Off button should be at the left side of the remote.