User's Manual

Walgreens Installation Guide

G-1-2002-2B

Walgreens Installation Guide 2B.doc

Use or disclosure of this document is covered under the Non-Disclosure Agreement executed between the reader and Goliath Solutions,

LLC. This document and the information contained herein are privileged and should only be viewed by expressly authorized parties.

5/27/2008 Page: 2-7

2) If the store has a Catalina Cabinet then go to step 3, otherwise the CMU will be

located by the Communications Cabinet in the Pharmacy.

Only enter the Pharmacy

if there is no Catalina Cabinet in the store. Notify the highest available level of

Store Management that you will need access to the Pharmacy. When in the

pharmacy the CIT must be accompanied by a Pharmacist that is on duty at all

times.

a) Minimize the time spent in the Pharmacy. Be very careful working in or near the

Communications cabinet and do not disconnect any network or power cables. This

cabinet is the heart of the stores communications system.

b) Locate the communications cabinet in the Pharmacy. Frequently the cabinet is

located near the entrance into the Pharmacy. The Pharmacist should be able to

help the CIT locate the cabinet if you don’t see it.

c) Open the communication cabinet and then locate the network switch or switches.

Most of the time the store will have one or two 48 port switches. The following are

the designated ports for Goliath:

 If there is only one switch, Goliath will use port 46 on that switch.

 If there are 2 switches, then Goliath will use port 46 on switch 2.

o To determine switch 2, look for the orange patch cable running from the

patch panel (normally port one on the patch panel) to one of the switches.

The patch cable will be plugged into one of the 4 ports highlighted in the

picture below. On occasion the cable can be a different color. Only one

orange patch cable should be used. The switch that the orange patch

cable is plugged into is switch 1. The other switch which would be daisy

chained to switch 1 is switch 2. Switch 2 will not be connected to the patch

panel. Frequently a red patch cable is used to connect Switch 1 and 2.

 If there are more than 2 switches or the designated port on the switch is not

available, then contact the Help Desk at the completion of the Pre-Installation

survey.

Switches