Installation guide

STEP 6:
ATTACH THE OVEN TO THE WALL
A WARNING &
You will need two people to lift this
microwave. Failure to use more than
one person could result in personal
injury.
power cord
power cord
1. Carefully lift microwave oven and hang it on
support tabs (See Figure 26) at the bottom of the
mounting plate. Reaching through upper cabinet,
thread power supply cord through the power supply
cord hole in the bottom of the upper cabinet. See
Figure 30.
2. Rotate the microwave oven upward so the top of
oven is against the bottom of the upper cabinet or
cabinet frame.
3. Drop the lock pin and washer assembly into hole
"N" (left side hole) and push the pin down as far as
it will go. See Figure 31.
4, Place washers over two 1/4"x3" bolts. Then insert a
bolt down through each hole in the upper cabinet
bottom.
Tighten the bolts until the gap between the upper
cabinet and microwave oven is closed. See Figure
32.
5. Remove lock pin and washer.
If wall-vented or room-vented installation is used,
go to No. 8 on the next page.
Figure 32
—17—