Installation guide

STEP 3:
PREPARE THE VENTING BLOWER
WALL-VENTED INSTALLATION:
1.
. Carefully lift the blower unit out of the microwave
Remove one blower unit mounting screw and one
blower plate screw. Remove the blower plate
from cabinet. See Figure 13.
back plate
blower unit
-—- blower plate
mounting screws
oven.
3. Use side cutters or tin snips to cut and remove Parts "B"
knockouts “B” from Back plate. Discard
knockouts. Be careful not to distort the plate. See blower unit
Figure
14.
mounting
screw
4. Reassemble the blower wire. See Figure 15. Figure 13
5. Rotate the unit so that the exhaust ports face the
. Place blower unit back into cabinet. Check that
. Reatiach the blower plate to cabinet so the
rear of the cabinet. See Figure 16. When you insert
blower unit, blower wire must be like figure 16.
the exhaust ports face towards the rear of the
cabinet. See Figure 17.
exhaust ports and blower plate opening are
aligned. Attach with one blower unit mounting
screw and then one blower plate mounting screw. Figure 14
See Figure 18.
exhaust
ports
Figure 15
Figure 16
—11—