user manual

8
Super Chlorinate
On
+
>
>
Turn super chlorinate on or off
Move to previous/next menu item
When you have an unusually high bather load, a large amount of rain, a cloudy water
condition, or any other condition that requires a large amount of chlorine to be introduced to
the pool, activate the Aqua Logic Super-Chlorinate function. The Aqua Logic will turn on
the filter pump, set the pool/spa valves to the correct position, and set the chlorine generator
to maximum output. The superchlorinate function will continue for the programmed number
of hours (see Timers/Super Chlorinate Hours below) overriding the normal filter pump timeclock
settings. At the end of the super chlorinate period, the pool will return to normal operation.
If there is a programmed period of spa operation (see Timers Menu/Spa below), then the
super chlorinate function will be temporarily suspended for the spa operation. At the end of
the spa operation, super chlorinate will resume for the remaining number of hours.
If you manually turn off the filter pump (using the “Filter” button on any display/keypad),
the super chlorinate function terminates. When you turn the filter pump back on, super
chlorinate will resume for the balance of the programmed number of hours.
Spa Chlorinator
3%
+
>
>
Adjust the desired chlorinator output for spa (0,1,2,3...9,10,15,20...95,100%)
Move to previous/next menu item
This setting will appear only if the system has been setup for “spa only” or “pool and spa”.
It will determine the chlorinator output when the system is operating in spa-only mode. The
actual amount of chlorine introduced into the spa is determined by: this setting, the amount
of time the pool operates in spa-only mode, the water temperature, and the amount of salt in
the water.
Pool Chlorinator
60%
+
>
>
Adjust the desired chlorinator output for pool (0,1,2,3...9,10,15,20...95,100%)
Move to previous/next menu item
This setting will appear only if the system has been setup for “pool only” or “pool and spa”.
It will determine the chlorinator output when the system is operating in pool-only or spa
spillover modes. The actual amount of chlorine introduced into the pool is determined by:
this setting, the amount of time the filter pump is running, the water temperature, and the
amount of salt in the water. If the filter pump is running due to the freeze protection feature,
then the chlorinator will not operate during this time.
Set Day and Time
Wednesday 10:37P
+
>
>
Adjust the current day of the week
Move to hours setting
Set Day and Time
10:37P
+
>
>
Adjust the current day of the week
Move to hours setting
Set Day and Time
Set Day and Time
+
+
>
>
>
>
Adjust the current hour (including AM/PM, if applicable)
Adjust the current minute
Move to minutes setting
Move to previous/next menu item
37
Wednesday
Wednesday
10: P
Use this function to set the current day of the week and time. These values are used for all
the automatic timeclock functions of the Aqua Logic and are also displayed as part of the
default menu.
The Aqua Logic is designed to keep the clock running during power outages lasting less
than 7 days. If power has been off for longer than 7 days, then the time may have to be reset.