Operation Manual

3
www.mdetectors.com
GM3+PB
Box of electronics
Made of ABS plastic and is very strong !
Arm support
It is made of aluminum profile for greater strength. In the front end of the handle is arm
supporter which is lined with foam coverage.
Battery box
The box is made of plastic. There are a set of 10 batteries АА NiMh- 1,2V/2500mAh.
5 . Assembly and disassembly of the instrument
Take the bottom (rack of Carbonic) put rubber sealing in outlets of the rack and insert it in the
crevice (ears) of the coil , till the outlets in the ears and the rack fall in. Insert the plastic bolt
in the hole and strongly pinch him to get out from the other end, turn the plastic nut to tighten
slightly.
Attention :
When the rubber sealings wear out they should be replaced, over tighting of nuts as a result of
worn rubber seals leads to deformation of the ears and doubling of the search drill .
Deformation of the drill greatly worsen parameters of the detector!
Then take the second part develop the plastic nut 6 and Insert it into carbon rack, with this
telescopic connection you can adjust the total length of the rack depending on your height
making sure the distance between the aluminum part and searching drill to be greater than 30
centimeters. Fixing the length is done by tightening the plastic nut.
Take part with the electronics, develop the large plastic nut 7 of the tube and insert in it the
rack with the drill. Then back to the thread and screw it tight so that the Detector can not
move to rack. Wind up the cable around the rack, and at the bottom end next to the rack put
an "ear" of cable, so it should not be interrupted when the cable reel in the retraction of the
transport situation.
Attention:
90% of the damage in detectors are becaouse of broken wires due to the negligent of the
users!