Owner's Manual

GoldenEar Invisa 600 Manual
11
10. While holding in place, tighten the four lock arm screws with a screwdriver (Figure 7). This will rotate the
lock arms and secure the speaker to the wall/ceiling. DO NOT OVERTIGHTEN the lock arm screws as this
could damage the drywall. If you are using a power screwdriver or drill, set the torque to a value of no
more than 7 in.-lb (8dN-m).
11. Install the grille by placing it over the installed speaker and aligning the powerful miniature magnets.
Setting the Invisa Speaker’s High Frequency EQ Control (HF EQ Switch)
We suggest starting with the HF EQ control (Figure 8) in the “+” position, in typical rooms with a balance of reflecting
and absorbing surfaces. If, however, your listening room is overly “bright” due to many reflective, hard surfaces,
select the center position to effectively compensate for this type of room acoustics issue. If the sound in the
listening position is still too bright, select the “-” position to compensate further.
Figure 7
Figure 8
LOCK ARM SCREWS
TURN CLOCKWISE TO TIGHTEN
LOCK ARMS AND SECURE
SPEAKER TO MOUNTING
SURFACE (4 PLACES)