Installation Guide

ManualsBrandsGolden Lighting Manualsceiling lightingGolden Lighting Three Light Semi Flush Ceiling Fixture from the Echelon Collection

Note: Complete these remaining steps after the fixture

is hung.

14. Secure threaded nipple (P) to bushing(M) of housing

and screw hex nut (N).

15. Place cap (O) over the threade nipple (P).

16. Screw finial (Q) to threaded nipple (P). (N).

17. Install the light bulbs in accordance with the fixture's

specifications.

(DO NOT EXCEED MAXIMUM WATTAGE RATING)

Fig 4

For Customer Service, contact the place of purchase to arran

e for replacement parts.

PARTS & ASSEMBLY SHEET

Fixture Name: Echelon 8981-SF BRI / GRM

ASSEMBLING THE FIXTURE as Chain hung (Fig.3)

6. Remove the Circular strap from top of Fixture and

replace the long mounting screws with two short screws to

hold the Deco nuts (R) in place on the fixture Top cap (B).

7. Feed the fixture wires through the Top loop (A) and

pull the wires until taut. Then screw the Top Loop（A） to

the coupling on the Top cap (B) until tight.

8. By measuring determine correct number of links

needed for proper hanging height. Use a pair of pliers to

open one link of the Chain (A2) then remove the excess

Chain (A2) and discard it.

9. Use one chain connector(A12) to attach one end of the

chain to the Top loop (A) and close the chain connector.

10. Feed the fixture wires through the Chain (every three

links) and pull the wires until taut.

11. Slip Canopy loop collar (A11) over the chain, then do

the same with the canopy .

Fig 3

* NOTE: The Finial can be scratched or broken if the full

weight of the fixture is placed on it. To avoid damage

attach the Bottom Assembly parts after hanging the

fixture.

4.Slide the center support of the Fabric shade(I) over

center tube to the housing, it is open on one side for ease

of assembly. Secure in place by tightening Cap nut (J) to

Frame (K) with frame of shade between them (I).

5. Hang 3 crystal draping chain (G) to hook (H) of shade.

* You may now install the fixture as semi-flush.

Fig 2

12. When ready to complete the installation Use the other

chain connector and attach the other end of the chain to

the canopy loop (A10) and close the chain connector.

13. Make sure the weight of the chandelier is supported by

the chain-not the electrical wire.

* You may now install the fixture.