Installation Guide
Assembly Instructions: 5926-FM (Saxon)
IMPORTANT:
• ALL INSTALLATION WORK SHOULD BE DONE BY ACCREDITED PROFESSIONAL.
• SHUT OFF POWER SUPPLY AT FUSE OR CIRCUIT BREAKER!
• USE ONLY THE SPECIFIED BULBS. DO NOT EXCEED THE MAXIMUM WATTAGE!
PREPARING FOR INSTALLATION
Carefully remove all of the contents from the carton. See the important notes above. Shut o the power at the circuit breaker and completely
remove the old xture from the ceiling, including the old mounting strap.
From the parts bag remove the mounting strap assembly. One end of nipple (C) should be attached to mounting strap (A) with washer (C) and
hex nut (D) in place. Attach mounting strap (A) to the junction box using mounting screws (B) and a screwdriver. Tighten securely.
CONNECTING THE WIRES
Have an assistant support the xture’s weight while completing the wiring. Cut away excess wire. Thread the xture’s wires through the nipple.
Attach the xture’s wires to the power supply wires from the junction box. Connect black to smooth/black/transparent (L) wire; white to ribbed/
white/transparent (N) wire; ground to ground (green or copper). Twist the ends of the wire pairs together, and then twist on a wire connector.
Make sure all twists are in the same direction. If there is no ground wire (green or copper) from the junction box, locate ground screw (E) on
mounting strap (A) and wrap the xture ground wire around the green ground screw (E). Use a screwdriver to secure ground screw (E) onto the
mounting bracket/mounting strap. Tuck all wires.
FINISHING THE INSTALLATION
Avoid touching the insulation with your bare hands. Raise
ceiling pan (G) up to the ceiling. Position nipple (F) so that it protrudes through the
center of ceiling pan (G). Secure ceiling pan (G) to mounting strap (A) by threading decorative nut (H) onto nipple (F).
Install light bulbs (not provided) in accordance with the xture’s specications. Do not exceed the maximum recommended wattage.
Your installation is complete. Turn on the power and test the xture.
For Customer Service, contact the place of
purchase.
CLEANING TIPS
Treat the xture gently! Regular cleaning will reduce the need for deep cleaning. For regular cleaning, turn o the light and wipe down the
xture with a clean lint-free cotton or microber cloth. Never spray cleaner directly onto the xture.
JUNCTION
BOX
B
E
G
D
C
F
A
H
I