Installation Guide

ManualsBrandsGolden Lighting Manualsceiling lightingGolden Lighting Mercer 2 Light 14-1/2" Wide Flush Mount Ceiling Fixture

Assembly Instructions: 4309-FM (Mercer)

IMPORTANT:

• ALL INSTALLATION WORK SHOULD BE DONE BY ACCREDITED PROFESSIONAL.

• SHUT OFF POWER SUPPLY AT FUSE OR CIRCUIT BREAKER!

• USE ONLY THE SPECIFIED BULBS. DO NOT EXCEED THE MAXIMUM WATTAGE!

PREPARING FOR INSTALLATION

Carefully remove all of the contents from the carton. See

the important notes above. Shut o the power at the circuit

breaker and completely remove the old xture from the

ceiling, including the old mounting strap.

From the parts bag remove the mounting strap assembly.

Mounting strap (B) contains threaded holes. Two of mounting

screws (A) should be attached to mounting strap (B). You may

need to tighten nuts (C) that hold these screws in place. Place

mounting strap (B) over the junction box so that mounting

screws (A) are vertical, and in alignment with the locations

of the holes ceiling pan (G). Secure mounting strap (B) to the

junction box with mounting screws (D) and a screwdriver.

Tighten the screws securely.

CONNECTING THE WIRES

Wrap or cut away any excess wires adding at least 2 to 3

inches of wire to the desired length. Attach the xture’s wires

to the power supply wires from the junction box. Connect

black to black (or smooth); white to white (or ribbed); ground

to ground (green or copper). Twist the ends of the wire pairs

together, and then twist on a wire connector. Make sure all

twists are in the same direction. If there is no ground wire

(green or copper) from the junction box, locate ground screw

(E) on mounting strap (B) and wrap the xture’s ground wire

around the green ground screw (E). Use a screwdriver to

secure ground screw (E) onto the mounting bracket. Tuck all

wires neatly into the junction box.

CLEANING TIPS

Treat the xture gently! Regular cleaning will reduce the need for deep cleaning. For regular cleaning, turn o the light and wipe down the

xture with a clean lint-free cotton or microber cloth. Never spray cleaner directly onto the xture.

For Customer Service, contact

the place of purchase.

FINISHING THE INSTALLATION

Lift ceiling pan (G) up to the ceiling and position the ceiling

pan so that mounting screws (A) protrude through the holes

in the ceiling pan. Tightly thread nuts (F) onto the exposed

threads of mounting screws (A).

Install light bulbs (not provided) in accordance with the

xture’s specications. Do not exceed the maximum wattage.

Raise glass shade (J) up and over coupler (H) which is at the

center of the ceiling pan. Secure the glass in place with top

cap (K) and bottom nial (L). Twist tightly.

Your installation is now complete. Turn on the power and test

the xture.