Instructions / Assembly

IMPORTANT:
• ALLINSTALLATIONWORKSHOULDBEDONEBYACCREDITEDPROFESSIONAL.
• SHUTOFFPOWERSUPPLYATFUSEORCIRCUITBREAKER!
• USEONLYTHESPECIFIEDBULBS.DONOTEXCEEDTHEMAXIMUMWATTAGE!
For Customer Service, please
contact the place of purchase.
AssemblyInstructions:3824-A1W
CLEANING TIPS
Treat the xture gently! Regular cleaning will reduce the need for deep cleaning. For regular cleaning, turn off the light and wipe down the
xture with a clean lint-free cotton or microber cloth. Never spray cleaner directly onto the xture.
Remove all of the contents from the carton. See the important notes above.
1.Mountingplate(N)isattachedtobackplate(F)alreadybythefactory.Removemountingplate(N)frombackplate(F).Holdthexture
uptothewalltotestplacementforbackplate(F).Afteryoudeterminetheproperplacement,holdmountingplate(N)uptothewalland
checkthatthesideholesareparallelandleveltotheoor.Useapenciltomarkthewallthroughthecircularholesinmountingplate(N).
2.Use a drill bit to create two holes on your pencil marks and insert plastic screw holders/anchors (M) into the holes made until
the plastic screw holders/anchors are ush with the wall.Align mounting plate (N) with the plastic screw holders/anchors (M).
Using a drill or screwdriver, insert mounting screws (O) into the plastic screw holders/anchors (M) halfway. Do not insert the
entire screw ush to the wall. Leaveafewofthescrew’sthreadsoutsideofthewallfornow.
3.Thexture’sgroundwireiswrappedinsideofbackplate(F).Leavethegroundwireunattachedandwrappedinsidethebackplate
4.Reattachmountingplate(N)tobackplate(F)byaligningthesideholesonthemountingplate(N)tothebackplate(F).Secure
backplate(F)tomountingplate(N)usingthesmallsidescrews(A).
5.Placethekeyholesinmountingplate(N)(whichisnowreattachedtobackplate(F))throughtheheadsoftheprotrudingmounting
screws(O).Slideshade(I)oversocket(H)andsecureinplacewithsocketring(J).
6.Installalightbulb(notincluded)inaccordancewiththexture’sspecications.Donotexceedthemaximumrecommendedwattage.
7.Plugcord(L)intothenearestoutlet.
8.Adjusttheaccordionlikefeatureoftheswingarm(C)asdesiredsuchasleft,right,closertothewall,orfurtheraway.
9.Pivotthelightsourcebytiltingthelampshadehead.Tolockthelightxturepositioninplacetightenthumbscrews.
10.Flipswitchoncord(L)topoweronthexture.Toturnthextureoff,ipthecordswitchagain.
To Install on a Wall and Power the Fixture Using the Plug...
This xture has multiple installation options. Before
beginning, please review these instructions carefully.
Thextureincludes
mountingplate(N)and
mountingbracket(B).
This installation uses
mounting plate (N).
How to Identify the Fixture’s Wires
Hot Neutral Ground
Smooth
Ribbed
Bare Metal,
Green, or
Green Inner
Thread
Black
White
Black Inner
Thread
White Inner
Thread
House Wires
Fixture Wires
Hot
M
N
O
F
A
H
I
J
L
C
N
G
N
D
B
N