Installation Sheet

Assembly Instructions: 3602-FM (Duncan)
IMPORTANT:
• ALL INSTALLATION WORK SHOULD BE DONE BY ACCREDITED PROFESSIONAL.
• SHUT OFF POWER SUPPLY AT FUSE OR CIRCUIT BREAKER!
• USE ONLY THE SPECIFIED BULBS. DO NOT EXCEED THE MAXIMUM WATTAGE!
PREPARING FOR INSTALLATION
Remove all of the contents from the carton. See the
important notes above. Shut off the power at the circuit
breakerandcompletelyremovetheoldxturefromthe
ceiling, including the old mounting strap.
Mounting strap (B) contains several pairs of threaded holes.
Find the pair of holes that matches the spacing of the holes
onthejunctionboxandyourcanopy.Twoofmounting
screws (A) should be attached to mounting strap (B). You
may need to tighten the nuts that hold these screws in place.
Pull the house wires through the center of mounting strap
(B),placemountingstrap(B)overthejunctionboxsothat
mounting screws (A) are vertical, and in alignment with the
hole locations on canopy (G). Secure mounting strap (B) to
thejunctionboxwithmountingscrews(D)andascrewdriver.
Tighten the screws securely.
CONNECTING THE WIRES
Attachthexture’swirestothepowersupplywiresfromthe
junctionbox.Connectblacktoblack(orsmooth);whiteto
white(orribbed);groundtoground(greenorcopper).Twist
the ends of the wire pairs together, then twist on a wire
connector. Make sure all twists are in the same direction. If
there is no ground wire (green or copper) from the junction
box,locategroundscrew(E)onmountingstrap(B)andwrap
thexture’sgroundwirearoundthegreengroundscrew
(E). Use a screwdriver to secure ground screw (E) onto the
mountingbracket.Tuckallwiresneatlyintothejunctionbox.
FINISHING THE INSTALLATION
Place canopy (G) over mounting screws (A) so that they
protrude through the holes in the front of the canopy. Thread
deco nuts (F) onto mounting screws (A). Twist until the
canopyofthextureissnugagainstthewall.
Slide shade (I) over socket (H) and twist washer (J) and
socket ring (K) onto the threads of socket (H) to secure in
place.
Installlightbulbsinaccordancewiththexture’s
specications.Donotexceedthemaximumrecommended
wattage.
Your installation is now complete. Turn on the power and test
thexture.
BLACK
(Hot)
WHITE
(Neutral)
GREEN
(Ground)
HOUSE WIRES
SMOOTH
(Or Black)
FIXTURE WIRES
RIBBED
(Or White)
BARE COPPER
(Or Green)
For Customer Service, contact
the place of purchase to arrange
for replacement parts.
CLEANING TIPS
Treat the xture gently! Regular cleaning will reduce the need for deep cleaning. For regular cleaning, turn off the light and wipe down the
xture with a clean lint-free cotton or microber cloth. Never spray cleaner directly onto the xture.
I
J
H
K
B
A
D
C
E
F
G