Installation Sheet

Assembly Instructions: 3602-14 (Duncan)
IMPORTANT:
• ALL INSTALLATION WORK SHOULD BE DONE BY ACCREDITED PROFESSIONAL.
• SHUT OFF POWER SUPPLY AT FUSE OR CIRCUIT BREAKER!
• USE ONLY THE SPECIFIED BULBS. DO NOT EXCEED THE MAXIMUM WATTAGE!
PREPARING FOR INSTALLATION
Remove all of the contents from the carton. See the important
notes above. Shut off the power at the circuit breaker and
completely remove the old xture from the ceiling, including
the old mounting strap.
1. From the parts bag remove the mounting strap assembly. One
end of nipple (F) should be attached to mounting strap (B) with
washer and hex nut (C and C1) in place. Attach mounting strap (B)
to the junction box using mounting screws (D) and a screwdriver.
Tighten securely.
CONNECTING THE WIRES
2.Haveanassistantsupportthexture’sweightwhilecompleting
thewiring.Refertothewiringdiagramandattachthexture’s
wires to the power supply wires from the junction box. Connect
Hot to Hot (transparent wire with black inner thread, black, or
smooth wire) Neutral to Neutral (transparent wire with white
inner thread, white, or ribbed wire), and Ground to Ground
(transparent wire with green inner thread, green wire, or copper).
Twist the ends of the wire pairs together, and then twist on a wire
connector. Make sure all twists are in the same direction. If there
is no house ground wire coming from the junction box, locate
ground screw (E) on the mounting bracket/mounting strap and
wrapthexture’sgroundwirearoundthegroundscrew.Usea
screwdriver to tighten the top of ground screw (E) onto the wires
and into the mounting bracket/mounting strap. Tuck the wires into
the junction box.
FINISHING THE INSTALLATION
3. Unscrew screws (L). Remove diffuser and metal ring (K and M).
Avoid touching the insulation (H) with your bare hands. Raise the
top of ceiling pan (G) to mounting strap (B). Position nipple (F)
so that it protrudes through the center of ceiling pan (G). Secure
xture(G)tomountingstrap(B)bythreadingdecorativenut(O)
onto nipple (F). Tighten securely.
4. Push shade (I) up to ceiling pan (G). Twist screw (A) into ceiling
pan (G). Secure in place by twisting shade (I) so that the key
hole locks onto screw (A). Install light bulbs (not provided) in
accordancewiththexture’sspecications.Donotexceedthe
maximum wattage.
5. Place diffuser (K) into metal ring (M). Raise metal ring (M) up
beneath shade (I) and twist screws (L) into each screw hole of
metal ring (M) securing it to the shade. Twist until secure.
Your installation is now complete. Turn on the power and test the
xture.
CLEANING TIPS
Treat the xture gently! Regular cleaning will reduce the need for deep cleaning. For regular cleaning, turn off the light and wipe down the
xture with a clean lint-free cotton or microber cloth. Never spray cleaner directly onto the xture.
For Customer Service, contact the
place of purchase.
A
H
G
I
J
L
K
M
N
O
D
B
F
E
C
C1
House Wires
Fixture Wires
Hot
How to Identify the Fixture’s Wires
Hot Neutral Ground
Smooth
Ribbed
Bare Metal,
Green, or
Green Inner
Thread
Black
White
Black Inner
Thread
White Inner
Thread